Lectrosonics CR185 Uživatelský manuál

CR185 COMPACT RECEIVER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repai

SPECIFICATIONS AND FEATURES Operating Frequencies: 150MHz to 216MHz, crystal controlled Sensitivity: Better than 0.6uV for 20dB quieting without co

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pu

INTRODUCTION Thank you for selecting the Lectrosonics Professional Series wireless microphone system. This system represents well over 10 years of

GENERAL TECHNICAL DESCRIPTION The CR185 receiver is comprised of six major functional subsystems: the RF front-end amplifier, the double balanced mix

CONTROLS AND FUNCTIONS RECEIVER FRONT PANEL MODULATION LEDs Indicate the modulation (audio level) of the incoming signal, and can be used for proper

- --CONTROLS AND FUNCTIONS Since the internal circuits are all tightly regulated the receiver will continue to operate to a battery voltage of 6.5 vo

RECEIVER REAR PANEL 12 VDC INPUT Connects to the supplied CH-12 AC adapter for powering the receiver from a 110/120V AC source. The receiver may also

ANTENNA USE AND PLACEMENT Connect the antenna to the front panel jack. Position the antenna so that it is not within 3 or 4 feet of large metal surfa

OPERATING INSTRUCTIONS 1) Connect the power cord or install the battery. 2) Attach and extend the antenna. 3) Connect the audio cable. 4) Set

TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the receiver (or a properly connected AC adapter).