Lectrosonics VS1 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Příslušenství komunikace Lectrosonics VS1. Lectrosonics VS1 User Manual [en] Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
VS1
VIDEO SWITCHER INTERFACE
OPERATING INSTRUCTIONS
and trouble-shooting guide
LECTROSONICS, INC.
Rio Rancho, NM
Zobrazit stránku 0
1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - LECTROSONICS, INC

VS1 VIDEO SWITCHER INTERFACE OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

Strany 2 - INTRODUCTION

TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE 1) Video image "rolls" when cameras are switched. 1) Auto Sync set to "Off" 2) No sync si

Strany 3 - THEORY OF OPERATION

SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair

Strany 4 - VS1 FUNCTIONS

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was p

Strany 5 - Rotate Time setting.)

INTRODUCTION The VS1 Video Switcher Interface is a microprocessor-based controller used between an automatic microphone mixer and a video switcher.

Strany 6

THEORY OF OPERATION The general operation of the VS1 will be described in this section, while the specifics of each programmable option will be outli

Strany 7 - INSTALLATION

VS1 FUNCTIONS Input Time Delay - Input Time Delay may be adjusted between 0.1 and 10 seconds. This parameter represents the delay between activity o

Strany 8 - SETUP PROCEDURE

VS1 Function Summary and Default Settings (Version 1.2 firmware) Feature / Function Range Factory Default Input Time Delay Outputs 1 thru 8: 0.1 to

Strany 9 - The SAVE button

FRONT PANEL DESCRIPTION SELECT PUSHBUTTON - Selects the area on the LCD display for which the Up and Down pushbuttons are active. The blinking cursor

Strany 10 - SPECIFICATIONS

INSTALLATION The VS1 has eight logic inputs, eight logic outputs, and a video synchronization input. The logic inputs provide the interface to an au

Strany 11 - RETURNING UNITS FOR REPAIR

SETUP PROCEDURE After the VS1 is installed as outlined in the Installation section (page 6) adjustments may be made to optimize the performance. The

Strany 12 - LIMITED ONE YEAR WARRANTY

5. Set the IDLE option to either HOLD or OVERVIEW. The Hold setting will keep the last active output on, while the Overview setting will switch to th

Komentáře k této Příručce

Žádné komentáře